|
Heel/Toe Accelerator Overlay for Porsche®
Application: Porsche® 928 1978-1995;
911 1978-89; 911 Turbo 75-77
 The Problem: The accelerator pedal
is too far to the right of the brake pedal to make heel-and-toe
downshifting easy. Poor downshifts are hard on your gears, and
limits your performance driving.
The Solution: Our bolt-on Accelerator
Pedal Overlay brings your pedal up slightly and to the left in
perfect alignment for heel-and-toe performance driving and shifting.
• Complete kit includes: Billet aluminum accelerator overlay
pre-drilled and ready to install
• Stainless steel mounting hardware
• Nylock-anti-vibration locknuts
Easy Installation: The accelerator
pedals on these cars were engineered for an overlay by Porsche.
On the back of the pedal, you will see the bolt-thru sleeves already
cast into the pedal. We designed our overlay to use these factory
bolt sleeves. Typical installation time from start to finish is
15 minutes or less. You will need only to drill three small holes
in your plastic gas pedal. Easy-to-follow instructions are included.
Quality Made: We cut these plates
from 6061 T-6 Aluminum Billet, then we apply a non-slip matte
finish.
|
