The Problem: The 3-wire connectors on your Porsche® ignition timing sensors and throttle position sensors were made from a molded material that becomes brittle and crumbles under heat and ozone.

These are commonly found at the:

• Crank reference Sensor
• Knock Sensor(s)
• Automatic Transmission Kickdown Switch

If your Porsche® has a mis-fire or a no-start condition, check the 3-wire connector coming out of the flywheel sensor. If, on an automatic transmission equipped car, you do not downshift promptly upon WOT, also check the 3-wire connection at the kick-down switch.

These 3-wire connectors are very hard to find, and we have a limited supply. Imported.

The Solution: Our 3-wire repair kit is a permanent solution to these problems. Your old faulty connector can be cut off and this new one crimped on in minutes.

Click to Enlarge	Click to Enlarge
Click to Enlarge	Click to Enlarge

© 928 Motorsports, LLC - All Rights Reserved
Horicon, Wisconsin USA